Description
Suitable for domestic use, Monsoon Standard pumps are suitable for installation into open vented hot and cold water systems.
Monsoon Standard pumps require a flow of just 0.6 l/min through the outlet to start.
Application
- Boost hot and cold water services to the complete home, bathroom, kitchen or cloakroom.
- Boost hot and cold water supplies to a high performance shower system.
Technical Details
Technical Specification
| General |
| Product code |
46415 |
| Guarantee |
5 years |
| WRAS approval |
1404702 |
| Features |
| Pump type |
Peripheral |
| Mechanical seal |
EPDM / PTFE / Al. Oxide |
| Anti vibration feet |
|
| Inlet strainer(s) |
|
| Flexible hoses |
4 |
| Dry run protection |
|
| Materials |
| Pump body |
Brass |
| Impeller |
Brass |
| Performance |
| Maximum head (closed valve) |
2.0 bar |
| Performance @ 9 l/min |
1.5 bar |
| Performance @ 18 l/min |
1.3 bar |
| Maximum flow |
55 l/min |
| Maximum static inlet pressure |
14 metres |
| Maximum working pressure* |
600 kPa (6 bar) |
| Maximum ambient air temperature |
40 °C |
| Min / Max water temperature** |
Min 4 °C / Max 65 °C |
| Flow switch sensitivity (approx) |
0.6 l/min |
| Connections |
| Pump connections |
G ¾ male |
| Flexible hoses |
| Connections (UK model) |
G ¾ female x 22 mm push-in
300 mm long
Isolating valves on all hoses |
| Connections (ROI model) |
G ¾ female x 21 mm push-in
300 mm long
Isolating valves on all hoses |
| Connections (Export model) |
G ¾ female x G ¾ female
300 mm long |
| Motor |
| Type |
Induction, auto-reset thermal trip |
| Duty rating |
Continuous (S1) @ 9 l/min and above*** |
| Electrical |
| Power supply/phase/frequency |
230 V a.c./ 1 / 50 Hz |
| Current (full load) |
1.9 Amps |
| Power consumption |
425 Watts |
| Fuse rating |
5 Amps |
| Power cable (pre-wired) |
1.5 metres |
| Physical |
| Enclosure protection |
IPX4 |
| Length |
265 mm |
| Width |
126 mm |
| Height (excluding hoses) |
202 mm |
| Weight (including fittings) |
7.2 Kg |
* The maximum pressure that can be applied to the pump under any installation conditions.
** A stored water temperature of 60 °C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.
*** Both heads pumping 4.5 l/min and above.
